Charnwood Island 3 Betriebsanleitung PDF herunterladen (Seite 11)

Blanking Plate

Clamping Plate

with fold horizontal

Back of the Stove

Seal Blanking Plate

with fire cement

Fig. 12. Flue Blanking Plate.

Horizontal lengths of flue must be kept to a minimum and should not

be more than 150mm. The sealing face of the flue collar should be

coated with fire cement before fixing to the body of the stove using

the two screws provided. The blanking plate must be removed, sealed

with fire cement and refitted, care being taken to ensure that the fold

on the clamping plate is in line with the lugs on the firebox as shown

on the label on the clamping plate (see Fig. 12). Ensure that the

clamping plate does not prevent the throat plate from seating

correctly. All flue connections must be well sealed.

S O O T D O O R S

It is possible to pass a 16 inch diameter sweeps brush through the

appliance but in most back outlet installations it will be necessary to

have a soot door to enable the chimney to be swept. This may either

be in the actual brickwork of the chimney or in the register plate.

Various types and positions of soot doors are shown in figures 8-11.

T H E R M O S T A T

Before lighting the fire check the cold setting distance of the

thermostat. This is fitted under the firebox.

With the control knob at the minimum setting the flap should be just

closed as shown in Fig. 13. To adjust the distance slacken the locking

nut and adjust as necessary. When set correctly re-tighten the locking

nut. Ensure that the flap opens and closes freely as the knob is

turned, and that the opening is completely covered when the flap is

closed.

P R E L I G H T I N G C H E C K

Before initial lighting the following points should be checked :-

1. The bottom grate bars must all be fitted and should move freely and

easily when the riddling mechanism is operated.

2. The plates round the sides and back of the grate must be in position

and sitting correctly

3 The throat plate must be fitted in the roof of the appliance and should

be checked to ensure that it has not become dislodged in transit. The

method of location and positioning of the throat plate is shown in Fig. 4.

4. The central heating and hot water system must be correctly

connected and filled.

C O M M I S S I O N I N G

On completion of the installation and after allowing a suitable period

of time for the fire cement and mortar to dry out, the stove should

be lit and checked to ensure that smoke and fumes are taken from

the appliance up the chimney and emitted safely. Also check all joints

and seals. If the rear flue outlet is used, ensure that the front

throatplate (Item 16 on the Parts List) has been removed. On

completion of the installation and commissioning please leave the

operating instructions with the customer and advise them on the use

of the appliance.

Fig. 13. Thermostat Setting

Thermostat Flap

Locking Nut

Flap just closed with

knob at minimum

Thermostat

Arm

Page 11

Island 3B 01.09

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Kommentare zu diesen Handbüchern

Keine Kommentare

Charnwood Island 3 Betriebsanleitung Seite 11

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Öfen Charnwood Island 3