Charnwood W650 Betriebsanleitung PDF herunterladen (Seite 9)

Loosely attach the leader pole (part no 35) to the machine (fig 16) then slide the rip fence

onto the leader pole (fig 17)

Clamp the rip fence onto the leader pole with the rip fence 5mm away from the saw blade

(fig 18) Set the leader pole using the five adjuster nut (fig19) to ensure the rip fence is

parallel to the blade then tighten with a 13mm spanner.

In order to fit the angle fence to the sliding table you will need the five components shown

(fig20)

Slide the two short aluminium sections (part no 15) onto the angle fence extrusion (Fig

21)

Drop work clamp through Short aluminium section (part no 15) and into the hole drilled

into the sliding table (fig 22) and secure with the grub screw using a 4mm hex key (fig 23)

Fig.24

Fig.25

Fig.17

Fig.18

Fig.19 Fig.20

Fig.21 Fig.22

1 2 3 4 5 6 7 8 9 10 11 12

Keine Kommentare

Charnwood W650 Betriebsanleitung Seite 9