Charnwood W730 Betriebsanleitung

14” BANDSAWOPERATING INSTRUCTIONSMODEL: W730Charnwood, Cedar Court, Walker Road, Bardon, Leicestershire, LE67 1TUTel. 01530 516 926 Fax. 01530 516 9

Setting up your saw Quick blade tensioner (shown in tight position). Looking from the front, turn in an anticlockwise direction to slac

The lower thrust and guide bearing are adjusted similarly. Guide bearing Locking screws Lower thrust bearing adjusting screw Release th

Unplug the bandsaw from the mains socket, slacken off the blade tension and open the upper and lower housing doors. Although there are two micro-swit

Parts List A – Saw Assembly

Parts List A No Name Qty No Name Qty 001 Lower door 1 002 Cap head bolt 4 003 Spacer bush 2 004 Lock nut 4 005 Nut 8 006 Joining block 2 007 Spr

103 Fence carrier 1 104 Plastic pressure plate 1 105 Self tapping screw 2 106 Cam 1 107 Handle 1 108 Cap 1 109 Shaft 1 110 Pointer 1 111 Cap head

Parts List B – Floorstand Cabinet No Name Qty No Name Qty B01 Left end panel 1 B02 Nut 1 B03 Front brace 2 B04 Washer 21 B05 Hex head bolt 16 B

GENERAL SAFETY RULES WARNING: Do not attempt to operate the machine until you have thoroughly read and understood completely all instructions, rules

19. Always wear a face or dust mask if operation creates a lot of dust and/or chips. Always operate the tool in a well ventilated area and provide f

Specification Table size 550 x 400 mm Table height 1000 mm Motor 1100W Blade length 2560 mm Blade widths 6 to 19 mm Blade speeds (no load) 370

Unpacking Cut the strapping, open the carton and remove all parts from the packaging Assembly Building the base This is most easily accompli

Bolt the cabinet on to base. Hold the door in position and fix the top hinge to the door frame with a self tapping screw.

Fitting the Saw to the Base Please note that this is a two person operation. You risk serious personal injury and possible damage to the machine if

This pointer is adjustable if the setscrew is loosened. You may need to make a small adjustment after the table is set perpendicular to the blade.

Screw in and lock the push stick hanger. Hang the push stick on it and remember that this is one of the world’s best finger preservers!